You are here : Home -> Products -> DIY KIT Series ->POF DIY Kit
POF DIY KIT POF DIY KIT

Description
Comoss developed whole POF DIY kit. Including POF patch cord, media converter and POF cutter. Through POF media converter is produced, we are glad to have a technology to guarantee our POF transceivers. The plugless connection technology is a new POF connection technology, With the COMOSS POF DIY KIT people can connect the fiber network.

Inquiry

Datasheet


facebook twitter plurk msn

POF DIY KIT

  1. FECON Series Media Converter……………….……....... 2 Pcs
  2. AC adapter……………………………………………………….....　2 Pcs
  3. UTP cable 40cm ………………………………………………....　2 Pcs
  4. POF cable 30 meters ……………………………………...…..　1 Pcs
  5. POF cable cutter……………………………………………………　1 Pcs

*All specifications are subject to change without notice.

Key Features
  1. Fully comply with IEEE 802.3u, 10/100 Base-TX and 100 Base-FX.
  2. Support one 10/100Base-TX RJ-45 port and one 100Base-FX OptoLock® or connector.
  3. Transmit signal up to 50 meters POF that meet IEEE 1394b Std.
  4. Display converter status by LED indicators.
  5. Support 10Mbps/ 100Mbps and full/ half-duplex operation at RJ-45 port.
  6. Support 100Mbps and full duplex operation at OptoLock® port.
  7. Plug-and-play and easy installation.
  8. Low power consumption and Low cost.
  9. MTBF: 35,000 hours
Procedure of connect POF cable
  1. Cut off POF cable
    Please use the reserved for the use of POF cable cutter, cut the length that you need
  2. Cut POF Cable
    Use POF cutter, cut & separate the front part of POF Cable（about 25mm）
  3. Pull out the flange till it is end.
  4. Plug the POF cable
    Plug the separated POF cable into each hole of OptoLock® connecter.
  5. Push the flange in
    Plug the POF cable into the bottom of OptoLock® connecter then push the flange back to the place it used to be.
    (If there is a sound like “click”, and that sound represents the cable has locked up already.)
More information and sample
LED Indications
POF DIY KIT indication
LED Color Status Function
PWR Red ON When input power is detected.
FX ACT Yellow ON If connection of POF is good.
FX LINK Green Blink When any FX packet is transmitting.
TX ACT Yellow ON If connection of copper cable is good.
TX LINK Green Blink When any TX packet is transmitting.

Order Information

DIY Kit - 100



Converter Type
  • 100: Throughputs 100Mbps

OptoLock® is a registered trade mark of Firecomms